Skip to Store Area:

Digisat Pro Accu MKII

Dobbelklikk på bildet for å se det i full størrelse

Zoom ut
Forstørre

Flere visninger

Digisat Pro Accu MKII

Tips en venn

Bli den første som omtaler dette produktet

På lager.

kr 999,00
Legg varer i handlekurven Legg i handlekurven

Oversikt

FEATURES
Measure signallevel from two LNB´s at the same time.
Measured information are displayed on the LCD.
DiSEqC, 22 kHz, 13/18v and mA readout.
Generate DiSEqC, 22 kHz and 13/18v to control LNB/switch.
Also works as a 2-way switch (13/18v, 22 kHz or DiSEqC).
Operates DiSEqC 1.2 actuators (East/West and reset).
Built in beeper, higher tone - better signal.
Very sensitive, easy to maximize weak and strong signals.
950-2150 MHz input frequency.
F-connectors, CE-approved.

Technical specification
Input frequency: 2 x 950-2150 MHz.
Input level: 40-100 dBuV.
Through loss: 5 dB.
Input impedance: 75 Ohm, F-connectors.
Output impedance: 75 Ohm, F-connector.
Short circuit protection: Automatic fuses on all inputs.
Measuring method: Signal presentation on LCD display
in form of thermometer scales
or three digit number. Pitch-tone
indication on loudspeaker.
Max-level: Thermometer-scales showing
max. Three digit numbers showing
highest value. Highest tone on
loudspeaker. Maxhold-function.
Voltmeter: Voltmeter 0-30 volt. 0-900 mA.
Indications: Voltage, current. 22 kHz (on/off).
MiniDiSEqC (toneburst). DiSEqC
1.0 and 1.1
Transmitting: 22 kHz (on/off). MiniDiSEqC (toneburst).
DiSEqC 1.0 and 1.1 13/18V.
Actuator control: DiSEqC 1.2.
Powersupply: Rechargeble battery or from
receiver via coaxial calble.
Power consumption: Ca 35 mA without loudspeaker.
Ca 50 mA with loudspeaker.
Battery recharge: Powersupply 14-20V DC,
Centerpin +, Car-charger.
Weight: 400g.
Dimensions: 175x 55 x 40 mm.
Accessories: Powersupply.
Carrying-case.
Car-charger.
Manual.
Technical specification



Digisat PRO er et brukervennlig instrument for kontroll og innstilling av parabol med fordelen at du kan se signalet fra 2 lnb samtidig. Kan brukes både på svake og sterke signal.
Kontrollerer om tuneren sender korrekt 22kHz- 13V/18V- og DiSEqC-signal. Dessuten kan den stilles inn og bruke både 22kHz- 13V/18V- og DiSEqC-switch.
Model DigPro
Manufacturer Digiality
Legg til tagger:
Legg til tagger
Bruk mellomrom for å skille tagger. Omgi setninger med apostrof (').